1. | What layer in the TCP/IP stack is equivalent to the Transport layer of the OSI model? |
A. | Application |
B. | Host-to-Host |
C. | Internet |
D. | Network Access |
Answer» B. Host-to-Host |
2. | You want to implement a mechanism that automates the IP configuration, including IP address, subnet mask, default gateway, and DNS information. Which protocol will you use to accomplish this? |
A. | SMTP |
B. | SNMP |
C. | DHCP |
D. | ARP |
Answer» C. DHCP |
3. | Which of the following is private IP address? |
A. | 12.0.0.1 |
B. | 168.172.19.39 |
C. | 172.15.14.36 |
D. | 192.168.24.43 |
Answer» D. 192.168.24.43 |
4. | MAC address is of |
A. | 24 bits |
B. | 36 bits |
C. | 42 bits |
D. | 48 bits |
Answer» D. 48 bits |
5. | A point-to-point protocol over ethernet is a network protocol for |
A. | encapsulating PPP frames inside ethernet frames |
B. | encapsulating ehternet framse inside PPP frames |
C. | for security of ethernet frames |
D. | for security of PPP frames |
Answer» A. encapsulating PPP frames inside ethernet frames |
6. | High speed ethernet works on |
A. | coaxial cable |
B. | twisted pair cable |
C. | optical fiber |
D. | none of the mentioned |
Answer» C. optical fiber |
7. | Address Resolution Protocol (ARP) is a |
A. | 8 Bit Field |
B. | 10 Bit Field |
C. | 12 Bit Field |
D. | 16 Bit Field |
Answer» D. 16 Bit Field |
8. | In Address Resolution Protocol (ARP), each LAN has been assigned a |
A. | Trigger |
B. | Integer |
C. | Repeater |
D. | Process header |
Answer» B. Integer |
9. | In Address Resolution Protocol (ARP), a packet is encapsulated directly into a |
A. | Data link Integer |
B. | Network Frame |
C. | Network Station |
D. | Data link Frame |
Answer» D. Data link Frame |
10. | If an Address Resolution Protocol (ARP) request is broadcast, an ARP reply is |
A. | Universal |
B. | Unicast |
C. | Multicast |
D. | Generated locally |
Answer» B. Unicast |
11. | Switching in Internet is done by using datagram approach to packet switching at the |
A. | network layer |
B. | application layer |
C. | data link layer |
D. | physical layer. |
Answer» A. network layer |
12. | A switch in a datagram network uses a |
A. | destination address |
B. | sender address |
C. | routing table |
D. | header |
Answer» C. routing table |
13. | A Virtual-Circuit Network (VCN) is normally implemented in the |
A. | session layer |
B. | data link layer |
C. | network layer |
D. | physical layer |
Answer» B. data link layer |
14. | Asynchronous Transfer Mode (ATM) network is an example of |
A. | Packet switching network |
B. | Datagram Networks |
C. | Virtual circuit network |
D. | message switched network |
Answer» C. Virtual circuit network |
15. | IPV4 Address is |
A. | 8 bit |
B. | 16 bit |
C. | 32 bit |
D. | 64 bit |
Answer» C. 32 bit |
16. | Internet Control Message Protocol (ICMP) has header size of |
A. | 12 Bytes |
B. | 10 Bytes |
C. | 08 Bytes |
D. | 06 Bytes |
Answer» C. 08 Bytes |
17. | Internet Control Message Protocol (ICMP) is companion of |
A. | IP Transmission |
B. | IP Packet |
C. | IP Frame |
D. | IP protocol |
Answer» D. IP protocol |
18. | IP is a connectionless |
A. | Source |
B. | Protocol |
C. | Station |
D. | Destination |
Answer» B. Protocol |
19. | Parameter that is normally achieved through a trailer added to end of frame is |
A. | Access Control |
B. | Flow Control |
C. | Error Control |
D. | Physical addressing. |
Answer» C. Error Control |
20. | Application layer provides basis for |
A. | Email services |
B. | Frame Division |
C. | File Making |
D. | None of the above |
Answer» A. Email services |
21. | In IPv4, value of Maximum Transfer Unit (MTU) depends on the |
A. | Physical network protocol |
B. | DataLink network protocol |
C. | UD protocol |
D. | Tr |
Answer» C. UD protocol |
22. | In IPv4 layer, datagrams are the |
A. | Frames |
B. | Addresses |
C. | Protocol |
D. | Packets |
Answer» D. Packets |
23. | The data link layer takes the packets from _________ and encapsulates them into frames for transmission. |
A. | network layer |
B. | physical layer |
C. | transport layer |
D. | application layer |
Answer» A. network layer |
24. | CRC stands for |
A. | cyclic redundancy check |
B. | code repeat check |
C. | code redundancy check |
D. | cyclic repeat check |
Answer» A. cyclic redundancy check |
26. | Which one of the following is a transport layer protocol used in networking? |
A. | TCP |
B. | UDP |
C. | Both TCP and UDP |
D. | None of the mentioned |
Answer» C. Both TCP and UDP |
27. | Transport layer protocols deals with |
A. | application to application communication |
B. | process to process communication |
C. | node to node communication |
D. | none of the mentioned |
Answer» B. process to process communication |
28. | Which one of the following is a transport layer protocol? |
A. | stream control transmission protocol |
B. | internet control message protocol |
C. | neighbor discovery protocol |
D. | dynamic host configuration protocol |
Answer» A. stream control transmission protocol |
29. | When displaying a web page, the application layer uses the _____________ |
A. | HTTP protocol |
B. | FTP protocol |
C. | SMTP protocol |
D. | TCP protocol |
Answer» A. HTTP protocol |
30. | Application layer protocol defines ____________ |
A. | types of messages exchanged |
B. | message format, syntax and semantics |
C. | rules for when and how processes send and respond to messages |
D. | all of the mentioned |
Answer» D. all of the mentioned |
Tags
Question and answers in Data Communication and Computer Network,Data Communication and Computer Network multiple choice questions and answers,Data Communication and Computer Network Important MCQs,Solved MCQs for Data Communication and Computer Network,Data Communication and Computer Network MCQs with answers PDF download